The studio snippet is taking over again! Over on my FaceBook page someone was asking for more detail about how I’m going about chasing in some shell-like forms on a piece in progress I shared. As I set about doing that I realized it was going to be a bit more of an involved effort than I normally put into such posts, since anything on FaceBook is essentially a flash in the pan, all but forgotten in a couple days. As this information might be something of perennial interest to at least a few people I thought I’d post it here instead. However, it is likely not of much interest to most people as it’s kinda technical geeky stuff about the metalsmithing technique known as chasing. Perhaps you non-chasers will find some interest in getting a deeper understanding of just what goes into such work, but you might also just want to skip this post.
Continue reading “Studio Snippet takes over: Specific details on chasing a small section of a vessel”